Samson 1200 Spezifikationen PDF herunterladen (Seite 8)

Guided Tour - Front Panel

8. Direct output - This standard male XLR connector provides a mic-

level pre-EQ (and pre-Volume) balanced low-impedance output from the

HS 1200. You’ll usually use this to connect the HS 1200 signal to a

Direct Injection (DI) box or to an XLR mic input when interfacing with

external sound reinforcement or recording mixing consoles. The signal

from this output adds approximately 6 dB of gain to the input level.

9. Headphones jack - Connect any standard stereo headphone

(600 ohms or less) to this standard 1/4" stereo jack. When a plug is

inserted into the headphone jack, the HS 1200 speaker output is muted,

enabling you to use the unit as a practice amplifier. The level of the

signal sent to the headphones is determined by the setting of the

Volume knob—when set to the point where a connected speaker would

clip, the headphones will clip.

WARNING: Because the HS 1200 is

capable of generating extremely high headphone signal levels,

always start with the Volume knob at minimum and then slowly

turn it up. In particular, a clicking sound is an indication of

distortion and possible damage to the headphones (and/or your

hearing!); don’t let things get to that point!

10. Power switch

- Use this to power the HS 1200 on or off.

11. Power LED - Lights whenever the HS 1200 is powered on.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Keine Kommentare

Samson 1200 Spezifikationen Seite 8