Samson MPL 1204 Spezifikationen PDF herunterladen (Seite 15)

Setting up your MPL 1204 is a simple procedure which takes only a few minutes:

1. Remove all packing materials (save them in case of need for future service)

and decide where the unit is to be physically placed—it can be mounted in any

standard 19" rack, requiring four rack spaces, or used on a tabletop.

2. Before even plugging the unit into an AC socket, begin by connecting the

MPL 1204 Main or Control Room outputs into a power amp and the amp into

loudspeakers (you’ll usually connect the Main output to a power amp in live

performance environments and the Control Room output to a power amp when

using the MPL 1204 for recording). It is never a good idea to power up any

amplifier that is not connected to loudspeakers.

3. Next, make the signal input connections to the mic or line inputs of the

various channels.

WARNING: Do not connect a channel’s line input if you

already have something connected to its microphone input, or vice versa; each

channel is designed to accept only one source or the other.

4. Set all channel Trim controls fully counterclockwise (to their “+4” setting) and

turn all channel Level controls fully counterclockwise (to their “∞” setting). Then

bring all four bus faders completely down (to their “∞” setting), and set the Main

and Control Room Level controls fully counterclockwise (to their “∞” setting).

Finally, connect the IEC main power cord and plug the MPL 1204 into any

grounded AC socket.

5. Turn on the rear panel Power switch—the “Power” LED in the main section

will light up.

Setting Up and Using The MPL 1204

SERVO - 240

SAMSON

MAIN

BALANCED <75Ω +4dBu

RIGHT

LEFT

SERVO - 240

SAMSON

CONTROL ROOM

BALANCED <75Ω +4dBu

RIGHT LEFT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Keine Kommentare

Samson MPL 1204 Spezifikationen Seite 15