Samson Go Mic Spezifikationen PDF herunterladen (Seite 16)

Go Mic Quick Start - continued

3. Next, connect your headphones to the PHONES output located on the right side of the

Go Mic.

4. Plug the mini-B size (small) end of the included USB cable into the USB socket on the

right side of the Go Mic.

5. Now, plug the other end of the USB cable into an available USB port on your

computer.

Note: Be sure to check the installation guide for Windows and Mac OS to confirm your

computer has recognized the Go Mic. Also, make sure your computer’s output level is set

to maximum for full volume in the Go Mic headphone monitor.

6. Next, launch your DAW, turn down the main output level and select the Go Mic for

the input and outputs.

7. Set up a mono record track in your DAW for the vocal track.

8. At this point you want to set the level of the Go Mic and there are few ways to do

this depending on your exact computer set up. You can set the microphone’s input

level in the Sound playback in Windows or in the Sound dialog box in the System

Preferences if you are using the MAC OS.

9. Set level of the microphone by raising the Input level control in your DAW or system

to about half way up. If you see the Power/Peak LED light red, your sgnal will be

distorted. Turn the MIC level control down until it does not flash red.

10. Next, put on your headphones, speak or sing into the mic and then raise the DAW’s

output level control until you reach a comfortable listening level.

Now, follow the instructions of your DAW software to enable the track for recording and

you’re ready to record.

Operating the Go Mic

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Samson Go Mic Spezifikationen Seite 16