Samson S2000 Betriebsanleitung PDF herunterladen (Seite 62)

Turn

→

Code 3, display: No

Press

→

Code 3 blinks

Turn

→

YES

Press , display

Select the initialization mode:

Initialization mode

Default

MAX

Turn

→

Code 6

Press

Turn

→

MAX

Press to confirm the MAX as the initial-

ization mode.

Start initialization:

4

Press INIT key to start initialization!

The nominal travel/angle of rotation is indi

-

cated in % after initialization. Code

5 (nomi

-

nal range) remains locked. The parameters

for travel/angle range start (Code

8) and

travel/angle range end (Code 9) can also

only be displayed and modified in %.

For a reading in mm/°, enter the pin posi

-

tion (Code

4).

Enter the pin position:

Pin position

Default

No

Turn

→

Code 4

Press , Code 4 blinks

Turn

→

Pin position on lever (see rele

-

vant section on attachment)

Press . The reading of the nominal range

appears in mm/°.

7.6.2 NOM – Initialization based

on nominal range

The calibrated sensor allows the effective

valve travel to be set very accurately. During

the initialization process, the positioner

checks whether the control valve can move

through the indicated nominal range (travel

or angle) without collision.

If this is the case, the indicated nominal

range is adopted with the limits of

travel/angle range start (Code 8) and

travel/angle range end (Code 9) as the op

-

erating range.

Note: The maximum possible travel must al

-

ways be greater than the nominal travel en

-

tered. If this is not the case, initialization is

interrupted (error alarm Code 52) because

the nominal travel is not achieved.

62 EB 8384-4 EN

Start-up – Settings

mm

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare